INSTALLATION OF THE TRANSOM WATER HOSE REPAIR KIT

       1)     REMOVE THE PLASTIC WATER FITTING ON THE INSIDE OF THE TRANSOM PLATE

       2)     REMOVE THE OUTDRIVE AND LOOSTEN THE BELL HOUSING.              

       3)     CUT THE WATER HOSE WITH ABOUT 1" LEFT STICKING OUT FROM THE TRANSOM PLATE.

       4)     WITH A BLUNT PUNCH OR LONG SCREWDRIVER CUT AND PUSH THE RETAINER PLUG FORWARD.

       5)      PULL THE LAST 3" OF HOSE FROM THE CAVITY IN THE PLATE.

       6)       REMOVE THE BALANCE OF THE HOSE STUCK IN THE BELL HOUSING BY REMOVEING THE END PLUG.

       7)        FEED THE REPAIR ASSEMBLY FROM THE ENGINE SIDE UNTIL IT IS 1" FROM THE GASKET SURFAFE.

       8)       PUT PERMATEX ON BOTH GASKETS AND PUSH IT THE REST OF THE WAY INTO THE CAVITY.

     10)       PUT THE SCREWS THROUGH THE FLANGE AND LOOK TO THR REAR TO CHECK THE HOSE IS AIMED CORRECTLY.

     11)      THE HOSE IS INDEXED UPON ASSY BUT IF IT IS OFF ANGLE IS OUT JUST REMOVE AND TWIST IT CORRECT.

     12)       REPLACE THE HOSE ASSEMBLY AND HOLD IT WITH THE PLASTIC INTERNAL HOSE FITTING AND SCREWS.

     13)      VERIFY THE LENGTH TO THE BELL HOUSING  IS CORRECT AND PUSH IT INTO THE BELL HOUSING CAVITY.

     14)      PUT THE TAPERED PLUG INTO THE REAR OF THE HOSE AND SCREW IT IN THE BELL WITH THE TOOL SUPPLIED.

     15)      YOU MUST BE SURE THAT THE HOSE DOESN'T TWIST WHILE THE PLUS IS TIGHTENED.

     16)      IF BECAUSE OF VARIENCE IN THE HOSE THICKNESS IS NOT TIGHT IN THE BELL AND CAN BE PULLED OUT.

     17)       A SMALL SLEVE OF SILICONE HOSE IS IN THE BAG,  PULL THE HOSE PAST THE BELL AND PLACE IT ON THE TIP.

     18)       GLUE MAY BE NECESSARY TO AFFIX TO THE HOSE,  PULL THE HOSE TILL FLUSH WITH FACE AND RE PLUG.

     19)        GOOD LUCK!  ANY QUESTIONS CALL 1-800-349-2628  1-800-FIX-BOAT

      20)     TO OBTAIN THE KIT ORDER  IM654

     9)        GOOD LUCK.