FREE HELP~FREE HELP~FREE HELP ~FREE HELP~FREE

INSTALL OF PART IM654

REMOVE THE BRAVO OUTDRIVE

REMOVE THE PLASTIC HOSE FITTING INSIDE THE TRANSOM (2 BOLTS)_

REMOVE THE EARMUFF SENDERS ON THE GIMBAL RING

REMOVE THE PIVOTBOLTS BEHIND THE SENDERS

REMOVE THE PLUG IN THE BELL END OF THE WATER HOSE AND PULL THE HOSE

CUT OFF THE WATER HOSE TO THE PLATE SHORT  (LEAVE 1")

IF THE BOAT END OF THE HOSE PLUG CAME OUT EASILY JUST PULL THE WHOLE HOSE WITHOUT CUTTING IT

IF CUTTING WAS NECESSARY ( THE PLUG DID NOT COME OUT) PUT A SCREWDRIVER FROM THE CUT END AND DRIVE THE PLUG OUT

PULL OUT THE SHORT END OF HOSE WITH A PLYERS

CLEAN OUT THE CAVITY WHERE THE HOSE WAS

 

INSTALLATION

 

BE SURE THE TWO GASKETS ARE IN PLACE ON THE S.S. PLATE

FEED THE HOSE FROM THE INSIDE UNTIL THE PLATE LINES UP WITH MOUNTING HOLES ON THE PLATE AND PERMATEX THE GASKETS AND REPLACE THE BOLTS ( IF THREAD DAMAGE GIVES PROBLEMS  USE THE STUDS)

REPLACE THE REAR END OF HOSE AND REPLACE THE BELL HOUSING

IF LARGE SPARK COMES OUT INSTEAD THE STARTER IS BAD

IM654